I applied a continuous bead of adhesive around the entire perimeter of the plexiglass – leaving a half-inch gap from the edge so there wouldn’t be too much overspill when I clamped pieces together. Rather than connect the boards to each other with screws, I simply glued the boards and the plexiglass together at one time. I wanted to be sure the magnets would never work themselves loose or pop out of the holes. Then I added a layer of glue in the holes and screwed the magnets in. I also didn’t want them too deep in case that would prevent them from sticking to the table. I didn’t want them sticking up above the wood and creating a gap where air would enter under the cover. I was careful to drill the holes deep enough to get the magnets flush with the wood. ![]() Once I cut the boards to size, I drilled a hole at each end of the 21-inch boards for the magnets. More tools for constructing an oil painting palette cover to keep the paints wet longer. I also ordered a couple of 18″ rolls of plastic wrap. I ordered that thinking it would save me time. So, I decided to make a large-roll holder with a slide cutter that would attach to the end of my palette table.Īfter finding parts at Lowes and ordering slide cutters online, and while I pondered over the best way to put it all together, I discovered a convenient plastic roll holder and slide cutter for 18-inch rolls on Amazon. I also have some large 2-foot rolls to wrap my framed paintings for shipping to galleries and shows. We use the Kirtland brand in our kitchen, and it comes with a convenient slide cutter. The first thought that came was to try out plastic wrap again because it was easy and readily available. That brings us to the options I considered over the past several months. So, I decided that removing the thin paint skin occasionally was easy enough since I was painting most days anyway. I found I was losing more paint and creating a bigger mess with the plastic than without it. It was also frustrating to try and get the palette covered before the static prone plastic folded over and stuck to itself. It can still be handy for plein air painting, but today I would probably use a disposable palette pad inside rather than glass.Ĭovering my palette with plastic wrap was a hassle because the plastic would stick to the paints. The lid also gave me trouble after a while when paint built up around the lid seal. ![]() Unfortunately, that made the palette a lot heavier. So I could use my razor scraper I had a piece of glass cut to fit in the bottom and sealed it with caulking. The problem I had was scraping dried paint off the soft plastic when I neglected to clean the palette right away. ![]() Neither approach to keeping my paints wet longer worked out well for me.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |